Single holder F 16mm 916F

Single Holder F 16mm – Installation in Concrete and Brick

The holder is made of steel and double-profiled—embossments extend to the base, increasing stiffness and resistance to bending under load. This is not only a rigid component but also a proven solution where deformation under the weight of cables or pipes must be avoided.

Installation is simple: a 6.5 mm diameter hole allows the use of DA anchor, MSD pin with TG screw, or BTS-5 concrete screw. No additional drilling or adaptation is required—just a standard concrete anchor that the installer already has in their toolkit. It also works on solid brick, calcium-silicate block, and natural stone.

Approval CNBOP (certificate no. CNBOP-PIB-KOT-2018-0037_3703) ensures compliance with Polish installation requirements. According to this standard, installation intervals can be set at 30 cm—the approved spacing for standardized installations. For special requirements (e.g., higher cable count or dynamic loads), the interval may be extended to 60 cm.

There are no plastic components or covers—this is pure steel that does not degrade due to moisture or temperature exposure. No concern about loss of stiffness over time.

Recommended load capacity: up to 12 kg per holder—sufficient for one or several cables up to 16 mm in diameter. This is not intended for heavy steel pipes or hydraulic lines, but is ideal for power, signaling, and fire alarm cables.

All F-series models (including 916F) are designed as part of a cohesive system—if you already have other F holders in your installation, this one will match both in appearance and mounting technique.