Water pressure changes happen and can be related to the way the water installation is designed. A very important element of the water installation is the water pressure reducer. It is worth finding out what exactly it is for, where it should be installed, and when it is worth using it.
What is a water pressure reducer intended for?
The water pressure reducer is used to maintain a constant pressure behind the main valve. Despite pressure fluctuations, the installation can be protected against excessive pressure. If too strong a stream of water affects the diaphragm, which lifts the spring, the reducer maintains the pressure at a safe level. The seal is lifted, and as a result, the optimum set pressure is achieved. When the pressure drops below the set level, the spring and pressure drop, which allows water to flow.
Check out water pressure reducers at the Onninen wholesaler
Where to install a water pressure reducer?
Many people wonder where to install a water pressure reducer . It is installed on the main supply line, behind the water meter and water filter. An alternative is to install pressure reducers in zones on the lines of heaters and tanks. However, this method of installation is very rare and is only used when it is impossible to install a pressure reducer on the main supply line or access to it is difficult. The installation of shut-off valves is important and should be located before and after the reducer. This makes it easier to set it up and maintain it. It is important to know that the pressure reducer is installed vertically in such a way that its body is not subjected to any further stress caused by the connection. Of course, the manufacturer's recommendations should always be followed when installing it. In addition to central and zone installation, you can also opt for distributed installation. In such a case, the water pressure regulator is installed near the boiler installation. At the same time, thermostatic heads are used. In such a case, a pressure bridge may form and the safety valve may leak. To prevent this, pressure reducers must regulate the flow of both hot and cold water. It is also possible to install a pressure regulator in supply systems. It is used in high-rise blocks to increase pressure.
Water pressure reducers at the Onninen wholesaler
In the Onninen wholesale offer you can find many reducers differing in the diameter of the connection threads. Reducers are available in a variant with the outlet pressure setting set to a specific value without the possibility of changing it and in a version with the possibility of changing the setting. Water pressure reducers may also differ in the material from which they are made. In the Oninnen wholesale you can choose a brass water pressure reducer . It is more resistant to corrosion than a steel reducer. You can choose a brass reducer with a cartridge design. A reducer with a pressure gauge is also available. A good choice may be a reducer with a built-in filter . If you want to regulate the pressure depending on your needs, you should choose a model with a pressure gauge. A reducer with a set operating scale is usually a cheaper solution.
Check out water pressure reducers at the Onninen wholesaler
When is it best to use a water pressure reducer?
A water pressure reducer must be purchased when the resting pressure in the water supply system exceeds 5 bar. If the resting pressure before the safety valve exceeds 80% of its opening pressure, a water pressure reducer must also be used. Too high pressure in the system may result in damage or improper functioning of the devices and systems that are part of it. Damage to flexible pipe joints may occur, or in extreme cases, the system may become leaky. Too low pressure in the system may also be a problem, and here the selection of the right water pressure regulator is important. In a situation where pressure fluctuations occur, a regulator is necessary. Reduced water consumption means that the pressure in the pipes may increase dangerously, hence the need for a water pressure reducer.
Is installing a water pressure reducer yourself a good idea?
Of course, you should not install a water pressure reducer yourself. It is better to entrust this work to a specialist, a plumber. He will not only install it correctly, but also adjust it. Thanks to this, the water installation will be much more resistant to failures.