Silver IR programmer TGRDSI001

Practical Controller for Wireless Heaters

The IR Silver programmer is a simple, battery-powered temperature regulator that operates without connection to the electrical grid – ideal for locations where easy access to a power outlet is unavailable. Powered by two AAA batteries, it requires no electrical installation and can be mounted on a wall or moved between rooms.

It works wirelessly with TERMA heaters equipped with an infrared receiver: KTX-4, One, and MOA IR. You can control multiple heaters in one room from a single device – no need to configure each one individually. The range in an open field is up to 12 meters, and in an enclosed room at least 3 meters, which is sufficient for most bathrooms and rooms.

Precise Control and Features for Everyday Use

Adjust the temperature in 0.5°C increments – from 10°C to 30°C – and view both the current and set values on the display. Four operating modes are available:

• manual – constant temperature,
• automatic – according to the programmed schedule,
• drying – intensive heating from 15 minutes to 4 hours, after which it automatically returns to the set mode,
• antifreeze – maintains a temperature that protects against freezing of water in the heater.

The 24-hour timer allows programming of on/off cycles every 15 minutes – for example, heating operates only during hours when the home is occupied. You can set two scales: economic (lower temperature) and comfort (higher), and the programmer will automatically switch between them at the designated times.

The temperature sensor can be manually calibrated – if the display shows a different value than the room thermometer, simply add or subtract a few degrees. This is a particular convenience for installers who must ensure measurement accuracy.

Simple Design, Safe Installation

The device features a minimalist form (80x80x23 mm), a lightweight construction, and a clear blue display – visible even in low light. Made of satin-finish silver plastic, it does not attract dust or fingerprints. The IP30 protection rating ensures resistance to dust and moisture typical of bathrooms.

Installation is simple: hang it on a hook or use adhesive tape (anchors not included). No wires or wall drilling are required – just hang it and insert the batteries. This solution is ideal for those who wish to avoid renovation or need flexibility.